Grundutbildning

Stirlingmotor
(2.7 timmar)
2D-ritning
(2.5 timmar)

Step By Step Training

Course Overview

Ruled Surface

Save to watch later?
Login to save things

Curve-Curve – Select two curves to create a surface between them. When each curve is selected, a match point will appear showing the connection point between each curve.  If the match points are not at the desired location, click the curve again to deselect and click the curve near the opposite end to change its match point location. An arrow will appear indicating the direction of the curve, click the arrow to reverse the curves direction so that both curves are pointed the same direction.

Curve-Point – Select a Curve and a Point to define the Surface.

Curve-Face – Select a Curve, an Edge for the Direction, and a surface to extend to. In addition, user can select the taper angle for the generated surface.

Normal To Face - Select a Curve and a surface that will define the surface to be generated normal to the surface from the curve path

This tutorial uses the Mechanical Add-on, click here to download it.
This tutorial requires the MultiPhysics Add-on, click here to download it.
Download the 3D files used in this course
This tutorial requires the KeyShot Add-on, click here to download it.
Click here to download the tutorial files used in these examples.
Download the 3D files used in this course
Ladda ned Övningsfiler
Ladda ned Övningsfiler
support@solidmakarna.se
08-556 185 48
Solidmakarna AB
Luntmakargatan 34
111 37 Stockholm
Kontakta IRONCAD Sverige

Ruled Surface